Pro-Grade #80-20

Force580DB

80dB (Cellular/ PCS/ LTE/ AWS) | Boost Signal for large buildings up to 80,000 sq. ft.
  • Independently reconfiguraable for each band
  • Digitally adjustable uplink and downlink
  • Supports All 2G, 3G and 4G standards
  • Covers all Canadian and US wireless carriers including Verizon and AT&T
  • Industry’s only product line of highly linear signal boosters
  • Thousands of successful installation since its introduction
  • Automatic Shutdown to prevent interference to cell towers
  • Auto Gain Control
  • Supports 100+ multiple users
  • Quality metal construction – durable and resilient
  • Uplink/Downlink Oscillation detection
  • Built in safeguards eliminate interference to cell towers
  • Industry best 3-year warranty
The Pro-Grade #80-20 is an alternative solution to a DAS but at a fraction of the cost. Modular in design, each unit provides enhanced cellular and data reception for areas up to 80,000 square feet for over 100 users. This full-featured signal booster includes adjustable gain control and automatic shutdown for network protection. The Pro-Grade #80-20 combines performance, value and durability. Compartmentalized design increases clarity and reduces noise. Our three-year warranty is a testimonial to the quality.
WARNING: This is NOT a CONSUMER device. It is designed for installations by QUALIFIED INSTALLERS. You MUST have an LICENSE OR express consent of an Licensee to operate this device.    *Outdoor and indoor antennas and cables are required for installation (purchased separately).
Frequency Uplink: 1850-1910/824-849/698-716/776-787/1710-1755 Downlink: 1930-1990/869-894/728-746/746-757/2110-2155
Input Impedance 50 ohm
Average Gain 80dB
Maximum Gain 80dB
VSWR ≤2:0
Standard Supported All 2G, 3G and 4G standards
AC Power Transformer 110V, 60 Hz
Maximum RF Output Power 27 dBm
Noise Figure 6dB
Cable LMR400 or CM400 recommended
RF connectors N Female connectors on both ends
Power Consumption <40W
Dimensions 10.05” x 7.5” x 2”
Weight 8.05 lbs

Note: Our boosters and amplifiers cannot transmit cell signals without an outside and inside antenna connected by a cable. We strongly recommend these antennas and cables as accessories for our boosters and amplifiers. However, the number of antennas, length of cable, or connectors needed can vary according to the size and make of the structure, lack of signal strength, or where the structure resides. Or you can contact us or our reseller to find out what you need.

SC230W outside antenna

SC230W

Full Band Outside YAGI Antenna

CM222W

Full Band Inside Dome Antenna

CM400

Ultra-Low-Loss Coaxial Cable

splitters

CM-WS(Option)

Full Band 2,3 or 4 Way Splitters